Most of the time, companies would spend lots of money to purchase their forklifts. It is important, therefore to take good care of your machine to protect your investment into the long run. It is really a great idea to know the procedures that are carried out during the maintenance and care of this piece of machinery.
By starting up the forklift and listening closely how it works is amongst the best ways to tell how good the engine is performing. Like for instance, if there are any misses or knocks, the machine is defective and this must raise some concerns. What's more listen carefully for any squealing noise that come from the belts since these sounds will provide you with a wealth of information.
When doing maintenance, some of the main parts you will have to pay attention to comprise the horn, safety warning devices, the overhead guard, the lights and the gauges. Any burnt out light bulbs or faulty components have to be replaced as soon as they are noticed. It is also vital to check the wiring.
When the above components have been inspected thoroughly, proceed to the battery compartment to be able to see if the terminals are clean. If the terminals are not clean, be sure to clean them well. Each and every battery cell has to be checked so as to ensure the fill level is topped up to the regulated amount.
The next step is to drain all of the oil out of the machinery and after that change the filters. The fuel filters, hydraulic filter and the transmission filter should be frequently replaced. Prior to fitting them, be sure to write the date on the new filters by using a permanent marker in order to keep track.
When the oil change is done and the filters have been replaced, a visual inspection of the drive axle has to be performed. If there is a grease fitting on the axle make certain to apply some grease. Inspect the engine belts for any cracks or frays. If you find any, fix the problem accordingly. Afterwards, inspect every other part of the equipment including the wheels. If any type of concern or fault is detected, be sure to address it immediately in order to make sure the machine is working at its safest and optimum levels.